Knex Shell Ejecting G36C

by slimshaddy

1.4K128

Intro: Knex Shell Ejecting G36C

This is my new creation it is a shell ejecting knex G36C that i got bored and made and the mecanisim it uses is the same one on my shell ejecting sniper that i made. I hope you like it please rate comment and subscribe!!

28 Comments

XxsonicxX 11 years ago

Nice dunkis shell ejecting gun mech. You really improved on his handle

The Chunky Sniper! 12 years ago

On the whole, good job, however it could look more like a G36C.

slimshaddy 12 years ago

yea it just has some added support it needed but i didnt have to have it

slimshaddy 12 years ago

i added some support on the stock that i shouldnt have

slimshaddy 12 years ago

i cant make the mag curved and be shell ejecting and the handle doesnt matter

The Chunky Sniper! 12 years ago

You can make a half - fake curved magazine, and if you want the replica to be accurate the handle needs to look more like this

slimshaddy 12 years ago

no its just not everything has to be exact

The Chunky Sniper! 12 years ago

If you call it a G36C, then at least have the courtesy to spend some time perfecting it.

slimshaddy 12 years ago

it looks fine the handle is a little diffrent ohwell

slimshaddy 12 years ago

ok i will have it up soon should i put the clip to or just the barrel part

DJ Radio 12 years ago

Doesn't look too much like the G36c, and you pretty much got that mech from the dunkis anyways.

slimshaddy 12 years ago

not the shell ejecting mec i didnt i came up with it
More Comments