Making Dr.Octopus Suit Based on Hydraulics

Intro: Making Dr.Octopus Suit Based on Hydraulics

So we will make an octopus doctor's suit with piping for the sleeves and impraboard for the outside. we made it with Azka, Zaidhan, Ahmad and Alif. We also put lights on the hands claws and put the

 battery to make the lights on. we use injection to make

the tentacles move. we also make the belt in the body of

the dr. octopus armor.We use two kinds of injection injection 10ml and 50ml.Hope you are interested!

STEP 1:

 1.Assemble the 4 claws required

with 8 injections measuring 10ml with hydraulics with a hose measuring 14 mm x 10 mm

2. Assemble the frame from PVC clothes

STEP 2:

1. Arrange the sleeves of the doctor octopus shirt with 8 10 ml injections with hydraulics

2. Hose measuring 18 mm x 14 mm

STEP 3:

1. Assemble the electricity for the Dr. Octopus shirt lamp.

2. Using the existing scheme. The electricity from the 3.7 Volt battery is connected to a DC step up to output 12 volts to light the 4 LED lights in each middle finger of Dr. Octopus' shirt.

3. Install a switch made of copper sheet.

4. Start trying it now!

Comments

[randofo]

That is really cool. I like how to claws work and light up.

[Achmad Choiruman]

The claw works when the hydraulics in the form of two syringes connected by a tube filled with water are pulled and the limit switch is pressed at one of the bases of the claw which causes the red LED to light up.