Portable Ipod Speaker With LEDS!!!
Intro: Portable Ipod Speaker With LEDS!!!
the fast and easy way to make a Portable ipod speaker
STEP 1: Parts
you will need an Altoids tin, a set of head phone, leds, AAA batters,Wire,switch, and a small speaker.
Tool: soldering iron, E-tape, and glue gun
Tool: soldering iron, E-tape, and glue gun
STEP 2: Strip the Head Phones
Just cut them off so you can see the 2 different wires
STEP 3: Make the Tin.
STEP 4: The Speaker
the first thing you want to do is feed the cord through the side hole then to the speaker to be solder
STEP 5: Now the Leds
first you will need about five leds in to a parallel circuit and fold then like in the picture.
STEP 6: Connecting the Switch
to connecting the switch solder two wires like so then connect them to the batters (i used tape)
STEP 7: Connecting the Leds
solder the 2 wires to the leds
35 Comments
Dr.Dooglestein 10 years ago
pancho del rancho 14 years ago
Adambowker98 12 years ago
ToxicHanz 14 years ago
ToxicHanz 14 years ago
drabinowitz 12 years ago
pancho del rancho 14 years ago
mistahmaxi 14 years ago
ToxicHanz 14 years ago
Coolboyme 14 years ago
well... i dont know much about electronics but still-
I have been doing this pin and speaker thingy since the time i got my ipod nano 5g. but i think the sound's too low. is there any simple way of making it louder?
pickilo 14 years ago
Philsterrox322 14 years ago
thestyrofoampeanut 14 years ago
knektek 14 years ago
schoonovermr 14 years ago
izatrini4eva 14 years ago
izatrini4eva 14 years ago
TSC 14 years ago
SmAsH! 14 years ago
bad?
paintsniper 14 years ago