Simplest Line Follower Robot
Intro: Simplest Line Follower Robot
a few days ago, i saw a robot at...
https://www.instructables.com/id/INTRODUCTION-24/
to be honest, the circuitry was a mess to see, although the schematic was simple, so i made a new PCB of it, and redesigned a little things, to get a very neat and small circuit of it....
this circuit needs:-
1.LM358 op-amp chip
2. 220 ohm resistors x 4
3. 1k resistor x 2
4. BC547B transistor (NPN) x 2
5. white LED x 2
6. orange LED x 2
7. 3 or 6V DC geared motors x 2
8. copper clad circuit board or protoboard
9. 20k pot x 2
10.5k pot x 2
11. photo-diode x 2
12. 9v battery
13. 100uf capacitor
i have given the circuit design [an eagle file], for making the PCB, you can adjust the space between the sensors in the design as per your requirment...
my robot's body is not so good, but it can work on any body, its is a very easy project to make... although it needs a little adjustments in the potentiometers, the first time... enjoy... :)
https://www.instructables.com/id/INTRODUCTION-24/
to be honest, the circuitry was a mess to see, although the schematic was simple, so i made a new PCB of it, and redesigned a little things, to get a very neat and small circuit of it....
this circuit needs:-
1.LM358 op-amp chip
2. 220 ohm resistors x 4
3. 1k resistor x 2
4. BC547B transistor (NPN) x 2
5. white LED x 2
6. orange LED x 2
7. 3 or 6V DC geared motors x 2
8. copper clad circuit board or protoboard
9. 20k pot x 2
10.5k pot x 2
11. photo-diode x 2
12. 9v battery
13. 100uf capacitor
i have given the circuit design [an eagle file], for making the PCB, you can adjust the space between the sensors in the design as per your requirment...
my robot's body is not so good, but it can work on any body, its is a very easy project to make... although it needs a little adjustments in the potentiometers, the first time... enjoy... :)
11 Comments
eagleanurag 9 years ago
REALLY AWESOME
SMARTIST
i love robotics and i want its pcb are you able to send me this By Post
see i live in uttrakhand and nothing available here
the money will be deposited in your account before your posting
also its parts
you can contact me
my mb. no. is
9756735700
Samartist 9 years ago
you should try to make your own pcb at home, there are methods by which you can do it, i have made it at home itself...
u can get all the components online except its pcb, there are many sites which will make this pcb if you give them this design file...
gahmad 8 years ago
Samartist 7 years ago
sorry for not replying, actually you must have the Photodiode and the LED parallel to each other, see any normal line follower design, plus your leds and photodiode will be attached on the other side of the board
gahmad 8 years ago
Ebabneshi 9 years ago
Hi. Can we ask for the C code for this project? Thanks. I look forward on your response.
Magesh Jayakumar 9 years ago
it looks good :)
Alejandro de Montecristo 9 years ago
Samartist 10 years ago
and LDRs dont even have polarity too... unlike photodiodes :)
eechavia 10 years ago
J-Five 11 years ago
I just might make this.