Origami Earrings
Intro: Origami Earrings
I like tiny, so I took 2 pieces of origami paper and cut into little pieces (1.875 cm). 60 pieces are needed per earring.
STEP 1:
fold diagonally
STEP 2:
mark the centre at the buttom
STEP 3:
fold centre down and up again, but slightly under the top, so you'll see a little of orange.
STEP 4:
fold the sides to top
STEP 5:
open one side and push down
STEP 6:
fold the piont down.
STEP 7:
fold the side double
STEP 8:
glew marked parts
STEP 9:
after drying
push each part a bit open (form the leaf)
Glew 5 pieces together to make 1 flower.
when you have 12 flowers,
glew 3 flowers together
push each part a bit open (form the leaf)
Glew 5 pieces together to make 1 flower.
when you have 12 flowers,
glew 3 flowers together
STEP 10:
now glew the 4 (3flowers) together, but don't forget to put a piece of wire in it.
Now get your pliers and make a 90 degree bend.
Now get your pliers and make a 90 degree bend.
STEP 11:
now grap the end and role it towards the corner.
place your earring in it
place your earring in it
STEP 12:
now polish it
7 Comments
Kyla544 9 years ago
I love these! They are so unique!
maryalma 10 years ago
ellierim 10 years ago
Thanks! Tthe tool is a folding bone. I used tacky glue and fimo (waterbased) vernis to polish.
armstk180 10 years ago
If you manufacture this , i am sure you can sell it in large stock
Good luck ...
ynze 10 years ago
mjcondon1 10 years ago
artfulann 10 years ago