X1000 Avenger Sniper Rifle V1

by Knex_Gun_Builder

4.9K589

Intro: X1000 Avenger Sniper Rifle V1

this instructable shows you how to make my x1000 avenger sniper rifle v1 its a sling shot with a new trigger system it gets about 130 feet of range.

STEP 1: Ammunition

this step shows how to make the ammunition.

STEP 2: Barrel

this step shows how to make the barrel.

STEP 3: Barrel Support

this step shows how to make the barrel support so it wont snap.

STEP 4: Trigger

this step shows how to make the trigger and connect it to the barrel.

STEP 5: Stock/handle

this step shows how to make the stock/handle.

STEP 6: Rubber Band Catcher

this step shows how to make the rubber band catcher.

STEP 7: Rubberbands and Rubber Band Mounting

this step shows the rubber bands and rubber band mounting.

STEP 8: Loading and Cocking

this step shows how to load and cock my gun.

STEP 9: Warning!

do not use more the one rubberband on this gun it will break the trigger.p.s have fun shooting!

91 Comments

knexrule2012 12 years ago

hey, can i possibly use this mech in one of my future guns???

STUNTMANIC101 13 years ago

Thanks I can final start building this thing

STUNTMANIC101 13 years ago

Not true I have three and two are really strong bands

Knex_Gun_Builder 13 years ago

Just a safety precaution, Don't want anyone getting hurt. Mine could only take one #64.

slimshaddy 13 years ago

i mean the part that connects to the supports

slimshaddy 13 years ago

what are some pieces that i can substitute because i only have 26 yellow connectors and 13 orange connectors.

Knex_Gun_Builder 13 years ago

the handle and the stock don't have to be made either, and I suppose you could skeletonize the barrel

Knex_Gun_Builder 13 years ago

You don't have to put the orange connectors on the bottom of the barrel, BUT YOU MUST PUT BLUE RODS IN THEIR PLACE!

slimshaddy 13 years ago

do you have to make the second part of the barrel
More Comments