Introduction: 12 Shot Pistol
I made this design after I built the 7 shot pistol by oodalumps. it fires 30+ feet with a few rubberbands. it fires 12 blue rods, one each time you pull back the firing pin and pull the trigger.it's my first instructable, so please be nice.
Parts list.
rods:
9 red/green
4 yellow
2 blue
1 white
4 black/green
connectors:
4 white
8 yellow
18 green
5 red/black
10 orange/black
16 grey (one joint)
other:
14 Y shaped pieces
1 ball joint
7 blue washers
3 grey washers (or 9 washers)
duct tape
blu tac
atleast 2 rubber bands
ps, sorry about the dodgy pictures
Step 1: Handle
make the handle
Step 2: Barrel and Trigger
construct the barrel
Step 3: Barrel End
construct these parts
Step 4: Hopper Cover, Firing Pin and Decoration
build all these parts and add duct tape to the firing pin to stop it snapping off
Step 5: Hopper
construct the hopper. this is probably the hardest step due to the amount of conectors on the rods.
Step 6: Begin Putting It All Together
place the ram into the barrel and attach the tan lock pin.
picture 2: push the red/black connectors together.
Step 7: Attach More Parts
attatch these parts to the back of the hopper
Step 8: Barrel Attachment
assemble the end of the barrel and attach onto the trigger section
Step 9: Barrel
fill in the barrel with these pieces
Step 10: Handle and Hopper
attach the handle then the hopper
Step 11: Hopper Cover
put the hopper cover ontop
Step 12: Rubber Bands
add trigger rubberbands and other rubberbands
Step 13: Loading
snap of the hopper cover and load in 12 blue rods, re attach the cover and pull back the firing pin. pull the trigger to fire.