Introduction: #09 TUTORIAL FUSION 360 - LEGO FLAG | PISTACCHIO GRAPHIC
Look how easy is to make a Lego Flag on Fusion 360.
Follow the tutorial video:
Follow my youtube channel tutorial:
Supplies
Software that was used in this project:
OBS Studio: Record the screen
Fusion 360: CAD design and PDF drawing instructions
Affinity Designer: Make the thumbnail
Affinity Publisher: Make the Technical Drawing E-Book
Step 1: Revolve Tool
To start our project we need to sketch the dimensions of the Lego Flag.
Follow the measurements in the PDF file.
Attachments
Step 2: Offset Plane
Make a offset plane with 6mm from the middle plane.
Step 3: Extrude Tool
In this step we need to extrude the profile to object
Step 4: Sweep Tool
Select the group of lines to make the sweep tool
Step 5: Fillet Tool
Attention to this step, make this fillets to round the sharp edge of the object
Step 6: Extrude Tool
Take off the middle of the flag
Step 7: Finish
To finish the object make some fillets and round the edges !!!!
