I designed and 3d printed a disc golf disc that flies very far. I currently attend Bonneville High School.

Supplies

For this project I used:

My 3d printer

Priline Flexible PLA

Fusion360 designing software

Step 1: Design Disc

I designed my disc models using Fusion360. It was actually very simple, I just sketched what I thought the disc cross-section should look like and then revolved it around the far edge. It took me a couple of attempts as you can see in the pictures, I ended up going with a flat top design with a thicker middle to print easier and add some more weight.

Step 2: Print the Disc

This part was harder than you might expect, the supports were quite difficult. That said I did get it printed and painstakingly took off all the supports.