3D Printed LED Casing

Introduction: 3D Printed LED Casing

About: i like making cool things that are on here, and making my own cool things and sharing them on instructibles.

With a watch battery, an LED, and a 3D printer.

Step 1: Do It.

See the pictures above to design your case. All you have to do is design one like this or you can make it different. We made a spaceship one with two holes for LED leads, an a normal one. For a button, I use my finger to push down the extra lead.
I made it to where the battery wouldn't fall out, also pictured above.

Make it Glow!

Participated in the
Make it Glow!

Formlabs Contest

Participated in the
Formlabs Contest

Be the First to Share

    Recommendations

    • Plywood Challenge

      Plywood Challenge
    • Plastic Contest

      Plastic Contest
    • Battery Powered Contest

      Battery Powered Contest

    2 Discussions

    0
    futurenavyseal
    futurenavyseal

    6 years ago

    Thanks, it's not hard. All you do is design a spot for the LED(leads are about 0.6mm in diameter) and a spot for the watch battery (about 11mm diameter if I remember right) and make it look cool. 1 tip for 3D printing it though is to be sure it follows the laws of gravity, or put support in it.