3d Printed Christmas Ornament

Introduction: 3d Printed Christmas Ornament

Christmas always makes me think of New Year's so for Re:3d's 2014 Christmas ornament I wanted to represent the new year somehow.

This model is designed without overhangs and is a 1-print model. The ball is permanently stuck inside the outer part and moves freely.

Had to decide whether to write 2014 or 2015 on the ball. On the one hand it's New Years 2015 but on the other it's 2014 Christmas.. Decided on 2014!

Print with a raft, 2 shells and 5% infill. .2mm layer height preferred.

Step 1:

3D Printed Ornament Design Challenge

Participated in the
3D Printed Ornament Design Challenge

Be the First to Share

    Recommendations

    • Plywood Challenge

      Plywood Challenge
    • Plastic Contest

      Plastic Contest
    • Battery Powered Contest

      Battery Powered Contest

    Discussions

    0
    seamster
    seamster

    6 years ago on Introduction

    Nice ornament! Thanks for sharing your design. Good luck in the challenge!