Introduction: 3d Printing Pen? - Manually Printing Models
I am wandering if it would be possible to create a hand held plastic printing pen for printing plastic parts by hand.
Step 1: Just Posting the Idea Out There!
The picture shows items that can be used to build a 3d printing 'pen'.
Step 2: Diagram
The driver is controlled by the button added to the soldering iron. (on/off)
The driver turns the plastic filiment reel.
The plastic filent travels down the brake cable shield into the soldering iron.
The plastic is melted in the soldering iron and comes out the end molten.
A potentiometer can be added to the driver for adjusting the speed of the motor.
The driver turns the plastic filiment reel.
The plastic filent travels down the brake cable shield into the soldering iron.
The plastic is melted in the soldering iron and comes out the end molten.
A potentiometer can be added to the driver for adjusting the speed of the motor.
