Introduction: 5 to 1 Gear
3D printed gears
Bevel gear design to create a 5:1 ration allowing a 200 rpm motor to drive the robot at 1 ft/sec
size restrictions dictated that drive fear must fin inside a .75" radius tube
Each gear was designed using solidworks and printed using a 3D printer at VCU
Bevel gear design to create a 5:1 ration allowing a 200 rpm motor to drive the robot at 1 ft/sec
size restrictions dictated that drive fear must fin inside a .75" radius tube
Each gear was designed using solidworks and printed using a 3D printer at VCU
![Wheels Challenge](https://content.instructables.com/FWP/R55O/HD4VMW5J/FWPR55OHD4VMW5J.jpg?auto=webp&frame=1&width=320)
Participated in the
Wheels Challenge
![Make It Real Challenge](https://content.instructables.com/FRF/E7W7/HD4VGCGI/FRFE7W7HD4VGCGI.jpg?auto=webp&frame=1&width=320)
Participated in the
Make It Real Challenge