Introduction: Aduino 16x2 Lcd Custom Char. Clock
If you want to make a DIY project
so it's perfect for you
and you also gift it to someone
Supplies
Need
>LCD 16x2
>Arduino UNO, nano
>atmega 3128p
>3x 10k resistor
>drill pcb
Body of clock
>ice cream stick
>hot gun with glue
>push switch x3
>wire
Step 1: Watch This Video
my channel
Step 2: Body of Clock
I'm using ice-cream stick
which I cut in this size and glue them
Step 3: Schametric Digram
these connection are as follows
the 10k pull-down resistor is used on the input
pin 10 ,9 ,8
Step 4:
for it making small I use atmega 328p
direct on pcb and the last i glue all the components and glue it is places
Step 5: Code
this is a simple code but not perfect. I future I make it perfect one