Arduino 4 Wheel Drive Bluetooth RC Car Using UNO R3, HC-05 and L293D Motorshield With Coding and Android App

Introduction: Arduino 4 Wheel Drive Bluetooth RC Car Using UNO R3, HC-05 and L293D Motorshield With Coding and Android App

Today I am going to tell you about how to make a arduino 4 wheel drive bluetooth RC car using HC 05 , L293 motor shield , 4 DC motor, with coding and app for android to control car.

Component used :-

1-Arduino UNO R3

2-Bluetooth HC-05

3-Motorshield L293D

4-4 DC motor

5-Android mobile

Step 1: Tightly Secrew to Motor to Chasis and Connect Wires in Terminal of Motors

Step 2: Join the HC 05 Blutetooth Module Wires to Arduino (as Per Diagram)

Step 3: Insert Motor Shield in Arduino As Shown in Pic

Step 4: Connect Motor Wires in Motor Shield As Shown in Pic

Step 5: Connect Saperate Power Wire for Arduino and Motor Shield

Step 6: Connect Arduino to Pc or Android to Upload the Program Given in Video Discription

Step 7: Remove HC 05 Wires Before Uploading the Program

Step 8: Install the App Given in Video Discription and Your Rc Car Is Ready

Be the First to Share

    Recommendations

    • Digital Fabrication Student Design Challenge

      Digital Fabrication Student Design Challenge
    • Build a Tool Contest

      Build a Tool Contest
    • Stone Concrete Cement Contest

      Stone Concrete Cement Contest

    5 Comments

    0
    RajaNabilla
    RajaNabilla

    Question 3 years ago on Step 7

    i cannot upload the program. help me... it stated that CPU speed not supported

    0
    RajS164
    RajS164

    Question 4 years ago on Step 4

    how to connect motor wires

    0
    rajanishad
    rajanishad

    Answer 4 years ago

    left side to left side pins and right to right

    0
    Swansong
    Swansong

    4 years ago

    That's a neat setup :)

    0
    rajanishad
    rajanishad

    Reply 4 years ago

    thanks