Introduction: Basic Loom Bracelet

By

this should be all u need and a loom i cant add the picture but ull also need that. this sure will be fun and this basic! hope u enjoy it :D .......

Supplies

Again this what u need...... A loom, a s clip, rubber bands (any colour u like make rainbow orrr pick 2 sets of colours or it can be random just anything ) and hook!

Step 1: Know Ur Loom

Now take the loom and turn it at the smiling side ! didn't understand? u can look at the pick to understand :)

Step 2: Place Rubber Bands

Now, u have to start making it

start by placing your rubber bands!

i am just making an example so i made SUPER DUPER SHORT but u have to make it long and from the Bottom..........

MY BAD

Step 3: LOOM PART (AGAIN)

After u are done placing ur rb (rubber bands) rotate the loom to the sad side just like shown in the pic

(if ur new it might take u time to understand)

Step 4: LOOPING TIME

NOW, take ur hook (sorry for the pick of the hook it was the only best pick i found....) AND NOW COMES THE SERIOUS PART (and fun) U HAVE TO START LOOPING

so in the pic as shown take the white part from ur hook

Step 5: LOOPING PART (20)

like this make kind ok a small fish and repeat the step ">"

till u reach the top

Step 6:

it should be like this

Step 7: ENDING(1)

Now take the s clip (the s shaped one or c if u prefer to...)

Step 8: ENDING(2)

Stretch the rb like shown in the pic to put in the s clip

Step 9: ENDING (3)

Insert it......

Step 10: ENDING

and now pull of the bracelet from the loom and on the other end (THE PART WHERE U DIDN'T ATTACH THE CLIP) stretch it between ur index and the thumb finger take the other side of the bracelet where the s clip is also attach the clip on the the side(where u didnt attach the s clip) attach the clip and ur READYYYYYYYYYYYYYY TO WEAR UR BRACELET TADAAA

HOPE U ENJOYED MAKING IT :D

ill soon make a tutorial to make a fish tail bracelet :D

BYE FOR NOW :D