Have an old bike you never use any more? Ya? Cool! Well this is a cool decoration you can hang on your wall or even christmas tree!

Step 1:

Step 1: take off your bike chain on your old bike your bike will not be useable after this unless you put it back on of course.

Step 2 before you disconnect the chain make a star or desired shape so you know how big it is going to be.

Step 3: Disconnect the chain at desired length just as it shows in the picture above.

Step 4: make your shape and connect the chains together again.

TIP: paint or clear gloss always looks cool!

Participated in the
Bicycle Contest

Be the First to Share

Recommendations

$Holographic Rainbow Reflective 3D Prints - 3D Printing on Diffraction Grating Sheets$

Holographic Rainbow Reflective 3D Prints - 3D Printing on Diffraction Grating Sheets by Penolopy Bulnick in 3D Printing

9 1.4K

Scrap Timber - Impossible Anti-Gravity, Cantilever Fish Bowl Stand / Planter Stand by Prob1e in Woodworking

187 15K

Mini Hydroelectric Concrete Dam by akashv44 in Science

57 8.1K

Belt-sander Linisher by stevemaskery in Woodworking

79 8.8K

Tinkercad to Fusion 360 Challenge
Remote Control Contest
Leather Challenge

4 Comments

Alowe104

6 years ago

Missing a few steps, a clean chain or un-rusted chain won't hold that shape. I made the star and I had to partially drive out several link pins to jam the chain into shape. Then I used fingernail clear coat to gloss it and make it stick to the shape better.