Introduction: CAD for CD Rack
After this Design session on my computer I hated the inventor of computers, but where would we be without him? so thanks.....
Anyway this is the CAD design I made and constructed. using it was very helpful as i was able to get the most accurate measurements and results.
There were 6 different pieces, 3 had slots on the top and 3 had slots on the bottom. Altogether there are 16 pieces!!!!!! Thank fully i had a friend how helped along the way.
Anyway this is the CAD design I made and constructed. using it was very helpful as i was able to get the most accurate measurements and results.
There were 6 different pieces, 3 had slots on the top and 3 had slots on the bottom. Altogether there are 16 pieces!!!!!! Thank fully i had a friend how helped along the way.
![Make It Real Challenge](https://content.instructables.com/FRF/E7W7/HD4VGCGI/FRFE7W7HD4VGCGI.jpg?auto=webp&frame=1&width=320)
Participated in the
Make It Real Challenge