Introduction: CIRCUIT OF OBSTACLE AVOIDING ROBOT USING TINKER CAD

so we are going to see how to create circuit of obstacle avoiding robot

Step 1: OBSTACLE AVOIDING ROBOT .

This is a Simple Obstacle Avoiding Virtual Circuit built using the TINKERCAD Simulation. In this project our Virtual Circuit is programmed to turn in left directin when the distance between robot and obstacle decreases to 10 cm or else it will continue its path.

Attachments

Step 2: COMPONENTS FOR CREATING THE ROBOT

The Following are the components required to make circuit.

  • Bread board - 1
  • L293D (Motor Driver) - 1
  • DC Motors - 2
  • Arduino UNO - 1
  • Ultrasonic sensor - 1

Step 3: Connections

Make the following connections as shown above.

Step 4: CodeBlocks

Finally Assemble thce codeblocks as shown using the tinkerCad Simulaton Enveroinment.