Introduction: Cellphone Travel Cable Organizer

This is a small box where you can store your cell phones

  • wall charger
  • car charger
  • charging cable
  • ear buds

It also has a nifty spot to prop up your phone

I printed on an ultimaker2. But most printers should work. I tried adding a latch but that did not work out so well. But the case is very nice with out the latch.

Step 1: Download

You can download the Fusion 360 project from http://a360.co/2v6ar8J

Step 2: Print Box

Go into fusion360. Open the project. select Print the box part of project

Step 3: Print Lid

print lid part of fusion 360 project

Step 4: Assemble

The lid slids into the box and there is storage for all your cell phone gear