Very clever on both approaches. I have always been accustomed to shutting off the power and getting a thin nose pliers onto part of the bulb socket so I could twist it out. I think those I have seen have always broken very low near to the metal base while leaving part of the structure that holds the filament.
I like this as it is not as wasteful as my half a potato method (make sure it's unplugged!)
X
Autodesk Instructables
Your privacy is important to us, so please take a moment to indicate if we may collect and use your data.
We want you to have a good experience with us. To do this, we collect data about your online behavior or attributes and use advanced data analysis so that we may deliver new versions of our sites with customized content.
3 Comments
bertus52x11 12 years ago
Phil B 12 years ago
dreamberry 12 years ago