Introduction: Controlling a Relay Module With an Arduino Uno and an IR Remote
This instructable is for connecting your Arduino to a 4 Channel relay module and using your sketch to control the switches.
Step 1: Step 1: Watch the Video!
Step 2: Step 2: What You Will Need
You Will Need-
- 1x Arduino Uno
- 1x 4 channel relay board
- 1x IR reciever
- 1x IR remote
Step 3: Step 3: Create the Circuit
And upload the code.
4 Comments
3 years ago
I want to control the relay with ir sensor using ardunio when power supply turn on again not to restart the relay.But my testing is autorestart the relay.
Please,give me advice.
4 years ago
hey i just bought TSOP 1738, after programming and all the connection i am facing a problem that i am receiving the hex values only on inserting TSOP and while removing it but not on pressing the button from ir remote. please can you provide any solution regarding this.
5 years ago
Nice instructable... :)
Please have a look at the below link as well using aurduino
https://www.instructables.com/id/Led-Cube-3x3x3-1/
5 years ago
So cool! What do you plan on using the relay module for?