Introduction: DIY Flashlight
Big gulp plastic cup or taco Bell large plastic cup
Tape or hot glue
Step 1: Step 1
Take glass out of magnifying glass and put in plastic cup, cut cup to fit glass, then cut bottom of cup to fit bottom of pill bottle.
Step 2: Step 2
Cut hole in bottom of pill bottle and hole in side of pill bottle to fit led pod button, once button is fit through put battery and most of the wiring in pill bottle.
Step 3: Step 3
Tape top back on pill bottle with led and wire sticking out, fit bottom of pill bottle through bottom of cup, take back off led and stick to bottom of pill bottle.
Step 4: Step 4
Put glass in and hot glue or tape all seams
Participated in the
Trash to Treasure Contest