DIY: Prototyping Cables

You have seen these cables everywhere........
you might have them ............. you might not  
but wouldn't you love it if you could attach to a wire of Ur choice
or even better make then from scratch your self???    
here is a simple yet almost free way of making these cables

you could buy them from various shops and online stores but that requires either waiting for it to arrive
or you going and buying it personally.

NOTE: This works on multistrand ( multicore) wire ..... i have not tried on single strand ( single core ) wire   and i don't intend to 

P.S    this is my first instructable.  

Step 1: So What's Needed Again???

You must be having everything at your desk right now!!!

wire ( duh)
bell pins 
breadboard ( optional)
arduino ( optional)
wire strippers ( optional)

the arduino i have is called an Induino ( India+arduino)
it is an Indian clone of the amazing arduino 
http://www.simplelabs.co.in/content/induinox-low-cost-arduino-usb-clone-board
check it 

Step 2: Procedure

Its very simple to make ........................
take ur wire 
strip it    
twist it 
wrap it around your pin 
push it back and make sure its tight
and ur done

Step 3: Going Further!!!

You want to make it permanent ?.................. solder it on 
go ahead and modify it to your liking
go and enjoy the world
oh yeah please rate it!!!