Introduction: DIY Self Watering Plant With 3 Objects!
Required Supplies:
1. An empty plastic 1 liter pop bottle.
2. A pair of large sharp scissors, or an exacto knife.
3. About half a cup of water.
Step 1: Fill It Up!
Take off the cap and fill the plastic bottle about three quarters full and give it a good shake to get out any leftover soda.
Step 2: The Wrapper!
Pull the wrapper off the bottle so that we have a nice, clear bottle.
Step 3: Cutting!
Use the scissors or exacto knife to cut the bottle in half. Then place the upper section upside-down in the bottle so that the top is almost touching the bottom.
Step 4: Fill It Up Again!
Fill the bottle up through the top so that only a little bit of water comes through the hole. (See picture)
Step 5: Dirt!
Put a large chunk of dirt in the bottle first so that the dirt doesn't fall into the water when added, and then add the rest of it!
Step 6: Final Step, Planting!
The last thing you have to do is plant a seed! Congrats! You just made a self watering plant using three objects!
