Introduction: Dismantled Echo 1 M4
Just some pics i thought id show of the chaos needed just to change the front sight. Im putting a flip up sight on it but couldnt get the flash hider off. Second Pic is the finished Gun. I Put a Flip up front sight, gemtech halo silencer, and G&P m120 high speed motor. Its shooting 17 RPS at 360 Fps.
Be the First to Share
Recommendations
Big and Small Contest
For the Home Contest
Make It Bridge
6 Comments
11 years ago on Introduction
what did you do? it cant be that hard to remove a front sight... or is it?
Reply 10 years ago on Introduction
its pretty difficult, I have an Echo 1 M16A4 and removed the front sight to add a solid gas block and upgraded it into an SR25, my fps runs about 750fps
Reply 10 years ago on Introduction
I would have to see the Chrono to believe that FPS value, but it sounds epic.
12 years ago on Introduction
all you have to do is remove the barrel to put a new front sight on you dont have to pull off the flash hider but if you dont want to pull the barrel off look for a small hex wrench and put it in the screw on the bottom of the flash hider
Reply 10 years ago on Introduction
Echo 1 adds a drop of super glue to the hex heads...you have to put the outer barrel extension into HOT water for about 5 min. then put a rag around the flash hider and use a pair of vice grips to get the flash hider off
11 years ago on Introduction
nice looks like an sr25