Introduction: Dorm Room Christmas Tree
Step 1: Gather Supplies
You will need:
•Green and red LEDs
•Soldering iron
•9 volt battery
•Switch
•Tweezers
•Solder
•Green and red LEDs
•Soldering iron
•9 volt battery
•Switch
•Tweezers
•Solder
Step 2: Switch
Solder one wire from the switch to the negative terminal. Make sure the other end doesn't touch.
Step 3: LEDs
One by one, solder the LED's ground wires to the other end of the switch. Bend the positive wires back and leave them alone.
Step 4: Arranging
Solder the lights so that there is three in the bottom, two in the middle and one red on the top.
Step 5: Positive Wires
Connect all the positive wires and solder them directly to the positive terminal. Make sure that wires aren't touching.
Step 6: Done!
Merry Christmas
![Supercharged Contest](https://content.instructables.com/FOL/YMU1/HP0CR5JT/FOLYMU1HP0CR5JT.jpg?auto=webp&frame=1&width=320)
Participated in the
Supercharged Contest
![Make It Glow Contest](https://content.instructables.com/FNH/LUA1/HMVJHDHA/FNHLUA1HMVJHDHA.jpg?auto=webp&frame=1&width=320)
Participated in the
Make It Glow Contest
![Hardware Hacking](https://content.instructables.com/FQP/QFV8/HNM4JKW4/FQPQFV8HNM4JKW4.jpg?auto=webp&frame=1&width=320)
Participated in the
Hardware Hacking