Introduction: EURO-Pallet Workbench - Simple
I was always looking for an workbench made of scrap wood or something like this.
So I took 2 Europallets and cut, put and nail them together.
Step 1:
These two you have to relaese and replace on the pallet.
Step 2:
The red one's i took from the second pallet and cut them on lenght to fit in the space.
Step 3:
I cut the legs of the second pallet for the lenght of the last block, after that i screw them into the blocks of the first pallet.
It's height is approx. 1,38 meters.
Step 4:
So it looks like when i put it in my garage.
2 Discussions
8 years ago on Introduction
neat! looks really easy too!
My question though is if it can really handle strong work, lets say installing a clamp on it?
Reply 8 years ago on Introduction
Sorry for not answering at once, but I was on vacation.
No it's not for rough work, I need to put in some stabilization.
I think it could be done until the end of September, then I'll update the "design".