Easy and Simple Pen Gun

Introduction: Easy and Simple Pen Gun

This is a very easy pen gun that doesn't require anything except the pen and a rubber band.

Also this is my first Instructable so please don't beat me with heavy sticks.

Step 1: Step One: Disassembling the Pen

This step is pretty easy. All you have to do is un-screw the cap and the little point... thing...

Step 2: Step Two: Assemble the Gun

Basically, you just put the rubber band around the pen and then twist it and put it around again 2 or 3 times.

Step 3: Step Three: Firing the Gun

Insert the pend cartridge into one end. Push it all the way through until it comes out the other end. Grab it and the rubber band together. Pull back the rubber band and let it go! It goes really far.
Note: Keep your thumb on the place where you wrapped the rubber band around. This will keep it from unraveling.

Be the First to Share

    Recommendations

    • Arduino Contest

      Arduino Contest
    • Barbecue Speed Challenge

      Barbecue Speed Challenge
    • Colors of the Rainbow Contest

      Colors of the Rainbow Contest

    6 Comments

    0
    johnmathew
    johnmathew

    12 years ago on Step 3

    Ha Ha Ha shoot him with his own creation.... XDXDXD

    0
    mcmarnin
    mcmarnin

    Reply 11 years ago on Step 3

    haha funny.

    0
    mcmarnin
    mcmarnin

    11 years ago on Step 3

    it was allright but not to impresing

    0
    ElvenChild
    ElvenChild

    11 years ago on Introduction

     I don't get it I searched macaroni and this instructable came up
    by the way the spell check says that instructables is misspelled