Fish Pleaser - Tinker Cad Contest - Silly Solutions

Introduction: Fish Pleaser - Tinker Cad Contest - Silly Solutions

My family has many pets. They range from dogs to snails. We realized that bonding with dogs is an easy task but not fish. I could get my fish to come to me briefly by holding up my hand in the water with food in it. But the interaction was only a matter of seconds. I decided to design something that would prolong this experience, I call it the Fish Pleaser.

Step 1: Design

The Fish Pleaser is a square receptacle with a slot on the bottom to insert a hook and loop strap. There is a ridge for the grid to slide into. The grid has a combination of larger and smaller holes for the fish food to be dispensed slowly.

To assemble

- Cut a length of hook and loop strap about 4 inches, insert into bottom of feeder and adjust around your finger.

- Insert fish food, slide in grid

- Your Ready To Go!

Tinkercad Student Design Contest

Participated in the
Tinkercad Student Design Contest

Be the First to Share

    Recommendations

    • First Time Author Contest

      First Time Author Contest
    • Make it Fly Challenge

      Make it Fly Challenge
    • Maps Challenge

      Maps Challenge

    Comments