Getting Started With PADI IOT Stamp Module From Pine64 | AT Commands.

Introduction: Getting Started With PADI IOT Stamp Module From Pine64 | AT Commands.

About: Basically i am a developer. I do work in both hardware and software.I like working on electronics and programming pretty much.Right now i am working on my smart home....

The IoT Stamp module is powered by Realtek RTL8710AF ARM Cortex M3 WiFi SoC running at 83 MHz. This module features same form factor and GPIO layout as of ESP8266 but lacks ADC input.
But it features

Up to 1x SPI @ 41.5 Mbps max

Up to 3x UART with 2x up to 4Mbps, 1x @ 38400 bps

Up to 4x PWM

Up to 1x I2C @ 3.4 Mbps max

Up to 19 GPIOs including 10 supporting interrupts. And it comes with 1 MB of flash and 512 KB of RAM.


Used Commands:




ATPW=1 //Station Mode

ATWS// Scan Wifi

ATPH=2,2// Mode AP 1/STA 2, Enable:DHCP 1/STATIC 2

ATPE= Static IP ATPN=weargenius,omisoksbwn// Connect to AP

ATW?// Wifi Info

ATPG=1 // Auto COnnect 0: Disable 1: Enable

ATPC=0,,80 // Create TCp Client

ATPI// Connection Info

ATPT=70,1:"GET /tut/index.php?NAME=bikash /HTTP/1.1 Host:\r\n"//Send Data

ATPR=1,20// rECEIVE dATA ATPD=0//0 FOR ALL OR conn_id

ATWD // Disconnect from AP


Resources from Pine64 Website:

IOT Stamp Resources:


Pinout Diagram:

AT Commands guide:

Getting Started Guide:


Subscribe YouTube :

Guys Subscribe to my channel for latest contents into your inbox.

Support me to keep going.

Support me on Patreon :


Website :

Twitter :

YouTube :

Instagram :



Be the First to Share


    • Make it Glow Contest

      Make it Glow Contest
    • First Time Author Contest

      First Time Author Contest
    • PCB Challenge

      PCB Challenge