Ghosts, Easy Halloween

Introduction: Ghosts, Easy Halloween

About: I'm a professional entertainer, mostly educational shows for elementary schools. I have one great wife and one great child, (3 years old). My proudest project is a Model of the Wright Brothers plane with a 2…

i saw these at Micheal's for $4 and figured I could make them at home for free, and Halloween decor should be free or close to it.  Almost too easy to publish, but a nice simple project to liven up the holidays.  Easy for kids. 

Step 1: What You Need

White sheet.
Cardboard, preferably thick, double corrugated.
A hollow ball of some kind.  Tennis ball racket ball,
Thread, wire, rope.
Knife, eXacto knife,

Step 2: Cardboard Cutout

Cardboard is all you need for this step, and just the head and arms, the body will be the flowing fabric. 

Step 3: Add 3D Head

I had these pieces of foam I shaped into two halves of a ball.  Then I found that a tennis ball works quite nice.

Step 4: Add Fabric

I cut out a square of linen, bed-sheet, white stuff.  I had some laying around, but the thrift store would have a big sheet for about a $1.
Find the middle and stick the head there, let the rest fall dramatically over the inner form. Then tie a string, noose, or wire around the neck to keep the shaped.

Step 5: Finishing Touches.

This is probably best hanging from someplace. 
Add a string on top. 
You can decorate by adding eyes and mouth with a Sharpie. Cutting the fabric to have more ragged flowing feel.  I was tempted to scorch the edges with a lighter to add a spooky touch.  Maybe I will still do that.

I think they could go without the eyes or mouth, but my four-year-old said they needed eyes, and I found on some issues it is not worth arguing with a four-year-old.   That is what I hope you take away from this instructable.

Halloween Decorations Challenge

Participated in the
Halloween Decorations Challenge

Be the First to Share


    • Science Fair Challenge

      Science Fair Challenge
    • Electronics Contest

      Electronics Contest
    • Tinkercad to Fusion 360 Challenge

      Tinkercad to Fusion 360 Challenge