Introduction: Hammer Trophy for IC
I made this to participate in the constructables contest hoping to win an amazon giftcard so i can help my parents buy christmas gifts.
Supplies
Create a rectangle big enough for a frame
Step 1:
create a rectangle big enough to hold the hammer
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
EXTRUDE REMOVE
Step 7:
Step 8:
Step 9:
Step 10:
Step 11:
extrude the rectangle
Step 12:
Step 13:
use 3 point arcs to make the back
Step 14:
extrude oval
Step 15:
make circle over other extruded circle and extrude
Step 16:
go to assembly and use fastened mate to connect