How to Make a Starburst Bracelet on the Loom!
Intro: How to Make a Starburst Bracelet on the Loom!
STEP 1:
Placing the bands:
STEP 2:
Placing the bands
STEP 3:
Go all the way up until your loom looks like this:
STEP 4:
Then you do the other side:
STEP 5:
Placing the burst bands:
STEP 6:
Then you do the same thing going clockwise.
STEP 7:
And you do the same thing all the way up.
STEP 8:
Flip the Loom around.
STEP 9:
Placing the capping bands, make a figure 8 and fold it back upon it's self.
STEP 10:
Actually placing the capping bands.
STEP 11:
Going all the way up.
STEP 12:
Looping
STEP 13:
Grab the top rubber band and loop it.
STEP 14:
This is what it should look like when you are done loop ing one starburst
STEP 15:
When you are done looping all the starburst it should look like this.
STEP 16:
Now lets loop the border bands. Don't worry, this part isn't near as hard as the part you just did. ;) first you get one of the side bands and loop it to it's original peg.
STEP 17:
Any you go all the way up until it looks like this.
STEP 18:
Then you do the other side.
STEP 19:
Tie a rubber band on the end.
STEP 20:
Pull it off the loom.
STEP 21:
Give it a clip.
6 Comments
Cutsie_101706 7 years ago
hey that really helped me thank you
Bellgirl101 8 years ago
that didn't help at all
Starburst loomer 9 years ago
You don't have to tie the band
HopeMuellerIsAwesome 9 years ago
Not even helpful at all.
ty159 10 years ago
thank you
sydney33 10 years ago