Introduction: How to Make Ambulance/Police Car Light With Arduino
Today, I will show you how to make Ambulance/Police Car Light With Arduino!
*** List Parts ***
- Arduino Nano (Or any board Arduino)
https://www.banggood.com/custlink/3GvEL7wuVK
https://www.banggood.com/custlink/3GvEL7wuVK
https://www.banggood.com/custlink/3GvEL7wuVK
https://www.banggood.com/custlink/3GvEL7wuVK
https://www.banggood.com/custlink/3GvEL7wuVK
Step 1: Disassemble the Car
I will disassemble the current car to check the status, the existing LED system
Step 2: Replace the Old LED System LED
Replace old 3mm LED system with 5mm LED (bigger, brighter)
Step 3: Connecting the Electrical System
Connect the electrical system according to the circuit diagram in the picture
Step 4: Reassemble
Reassemble the car as it was
Step 5: Programming and Running Tests
Upload the program for the Arduino board and run it.
DOWNLOAD SOURCE CODE BELOW
The two green and red lights will flash alternately.
So it's success!
