Introduction: How to Mod Your Nerf NiteFinder: Reinforce and New Spring
More by the author:
About: Hey everyone! I go to this site very often and in 12 months I have had 600 replies! I like knex, nerf guns, websites, video editing, origami, rockets, pen guns and more! This is my favorite comment:
kNeXFreek…
Hey everyone! This video will show where to put epoxy putty and where to get your stronger spring. I forgot to add that you can use the #49 spring from Ace Hardware and the K19, or K25 from McMaster. Also I realized that the audio was very rushed, so you'll probably have to re-watch it. Other Nerf Nitefinder Mods: http://www.youtube.com/watch?v=_Aya8kGt-UA (Coupler Mod)
http://www.youtube.com/watch?v=VUbJ6lSWx-E (AR Removal, spring stretch, Vacuum load)
Thanks for viewing! Please comment, rate, and subscribe! Also please visit my website at www.FarmHobbies.weebly.com!
10 Comments
12 years ago on Introduction
How hard is it to cock the 9713?
Reply 12 years ago on Introduction
A LOT easier to pull than the k25 or k19. I believe it's 20 something pounds of strength to pull the whole spring rather than the K25 which is 6 pounds per inch. I reccomend the 9713
Reply 12 years ago on Introduction
Yeah. I got the spring about a few days ago. Still pretty hard for me due to the fact that im only... Well, not old enough to register for nerfhaven.
Reply 12 years ago on Introduction
Oh lol! Then I guess you should just stretch the spring or add a Maverick Spring.
Reply 12 years ago on Introduction
I really don't think a mav spring would give it any boost in power though =P I guess ill just cut the spring like you did. I think I'll be able to cock it with 4 coils off. Any recommendations for cutting springs other than bolt cutters?
Reply 12 years ago on Introduction
Hmm.... Maybe you can try to use vise grips to hold both sides down, then use a dremel with a cutting wheel attachment. That's what I did. Or you can use a grinder.
Reply 12 years ago on Introduction
Nvm. Got a bolt cutter at harbour frieght for about 4$.
Reply 12 years ago on Introduction
LUCKY! I wish there was a Harbor Freight near where I live. The closest one is like 3 hours! I would've to buy online and pay for shipping =(. I got a lot of coupons for them too! The magazines I get (Popular Science, Popular Mechanics, and Discover) have Harbor Frieight coupons! But I heard that the stuff they sell breaks easily. I'd rather have a drill that lasts 5 years than a cheap one that lasts 5 months.
Reply 12 years ago on Introduction
That sucks! My nearest harbour frieght is a bit less than an hour away. I also got 50 hot glue sticks for about $1.40, and a mini rotary tool. The rotary tool sucks, but its good if you're patient. It's as small as a flex shaft!!! And of course, i had to not notice the 20% off coupon in pop sci.... But the bolt cutters worked well.
Reply 12 years ago on Introduction
Scary dremel sparks....