How to Use 28BYJ-48 Stepper Motor With 3 Push Buttons

Introduction: How to Use 28BYJ-48 Stepper Motor With 3 Push Buttons

About: Im no pro at Arduino to be honest! But i will do my best to share what i know about this subject!

Do you want to controll your stepper motor using push buttons? That can do Clockwise, Counter Clockwise and then Stop function? Then this video is for you!

Step 1: Watch the Video!

First of all watch the video all the way for you to understand my instrucable.

Step 2: Component Lists

This are the components that i used for this project.

-28BYJ-48 Stepper Motor x1

-ULN2003AN Stepper Motor Driver x1

- Push buttons x4

- LiquidCrystal I2C Display x1

- Male to Female connector

- Jumper Wires

- Breadboard x1

- Arduino Pro Micro

Note: I use Arduino Pro Micro on this project because i used Breadboard for this project. But you can also replicate this project by using Arduino Uno.

Step 3: Do the Wiring!

Connect everything according to this schematic.

Step 4: Programming

Okay after connecting everything according to the Schematic in Step 3. download this code and Upload it.

NOTE: If you want an Explaination about this code go watch the entire video in my youtube i explained it there and if you're kind enough go subscribe and hit the notification bell thank you!

Step 5: CONGRATS!!

Congrats you have successfully created my intrucables! Even so don't forget to like share and subscribe to my youtube channel and i will see you next time 😊

Be the First to Share

    Recommendations

    • First Time Author Contest

      First Time Author Contest
    • Maps Challenge

      Maps Challenge
    • Metal Contest

      Metal Contest

    Comments