Introduction: How to Make a Knex Bow and Arrow
I was bored and wanted to make something so here it is. And bare with me this is my first instructable.Please feel free to use constructive criticism.
Step 1: Items You Will Need
You will need 2 green or black mini rods, 2 right angle connectors, 1 orange connector, 1 rubber band, 1 blue rod.
Step 2: Main Part
First connect the mini rods to the orange connector.
Step 3: Bowstring
Now cut the rubber band and tie each end to a red connector.
Step 4: Putting All Together and Firing
Connect the the main part to the right angle connectors. Put either a blue, orange, or a red rod into the orange connector hole pull back and release. Also feel free to copy and add to this design, but give me credit.
12 Comments
6 years ago
.............
13 years ago on Introduction
And think of it as this, a low friction barrel.
13 years ago on Introduction
a Message to all. this isn't worthless. It can go through paper like a hot knife through butter.
13 years ago on Introduction
I kinda like it :-p
Reply 13 years ago on Introduction
me too.
13 years ago on Introduction
im tring to come up with a rubber band pistol
13 years ago on Introduction
well thank you IaC
13 years ago on Introduction
i think it is great of you to post something, but next time, please post something a little more complex. not many people like these things. good luck!
13 years ago on Introduction
Terrible, and terribly overrated. Please look around the site before posting guns like this.
13 years ago on Introduction
theres enough things on this site that r quick and easy. dont post worthless stuff
13 years ago on Introduction
thank you and i know about the bow thing i just didnt want to make something to complicated because i wanted to make it quick and easy
13 years ago on Introduction
Strictly speaking with bows, the "string" is non-elastic. and the energy is stored in the bow. However, your pictures are very sharp and show the build well. L