Introduction: Iframe

In this instructable I will be showing you how to make an iFrame. Basically what an iFrame is just an iPod put in a wooden frame. Then what you do is go into your pictures and start a slide show. I would be like a digital picture frame but just a little different.

Step 1: Supplies

To make an iFrame you need is:

1. Wood

2. iPod

3. Midair Box

4. Saw

5. Combination square

6. Pencil

Step 2: Get Your Wood

For me I like t use my own wood. I go out to a nice tree and cut off a good piece for the project that I am doing. The reason I do this is because it is cheaper than buying the wood and also it gives the project a rustic kind of look.

Step 3: Cutting the Wood.

Now the next step in the project is To cut the wood.First measure out the perimeter of your iPod then cut the wood to length. Also to make it look nice use 45 degree angle. My iPod has an 13in. perimeter(4 1/2in x 2 1/4in).

Step 4: Assembling the Wood

Now the next step to the project is to assemble the wood. All you need to do in this step to nail or screw the pieces together.

Step 5: Attaching the Back

For this step you need a flat piece of wood. I used a piece of card board because i was easier to attach to the frame. Also I used Light duty wood staples to attach it to the wood.

Step 6: The Stand

Take and cut a 4in piece of wood and the put a screw in it. Then to attach it to the frame drill two holes to put the screw in.

Step 7: Your Done

Now just put your iPod in the frame and put it on a slide shod and then you have your very own iFrame.