Introduction: K-nex Artillery Car
This is an artillery car made out of K-NEX. This is my first Instructable and my first K-NEX gun so if there is anything that you think would make it better please comment. It doesn't have a trigger so you just pull it back. If you have any ideas on how to make a trigger please comment.
Step 1: The Parts.
These are the parts you are going to need.
1 silver motor.
12 grey connectors.
2 orange connectors.
4 yellow connectors.
4 white connectors.
6 white sticks.
7 green sticks.
7 blue sticks.
6 grey sticks.
1 rubber band.
2 small wheels.
2 middle size wheels.
2 silver connectors.
2 tan wheel connectors.
4 blue spacers.
pictures and names of supplies below.
1 silver motor.
12 grey connectors.
2 orange connectors.
4 yellow connectors.
4 white connectors.
6 white sticks.
7 green sticks.
7 blue sticks.
6 grey sticks.
1 rubber band.
2 small wheels.
2 middle size wheels.
2 silver connectors.
2 tan wheel connectors.
4 blue spacers.
pictures and names of supplies below.
Step 2: Putting Together the Axle and Wheels.
This is how you put together the axle and wheels.(Shown below.)
Step 3: Putting on the Frame.
This is how you put on the frame.(Shown below.)
Step 4: Putting Together the Gun.
This is how you put together the gun. (Shown below.)
Step 5: Putting the Gun on the Frame.
This is how you put the gun on the frame.(Shown below.)
Step 6: How to Shoot It.
It doesn't have a trigger so this is how you shoot it.(Shown below.)