K.B.K (Knex Bug Killer)

Check my Shrapnel Spreader too, as it's the first ever knex time bomb on the site!

This is a pretty sweet little K'nex gun, inspired by Killerk's block trigger pistol.I
t shoots about 35 ft with one rubberband double-folded.
With two rubberbands please, do use in combat :D.

Pro's:
-Very good power/weight ratio.
-Sturdy design.
-Easy to shoot.
-Good accuracy.
-Low parts-use.

Cons:
-Block trigger!

Step 1: Trigger Spacers

Buid this part twice.

Step 2: Handles

Build this twice aswell.

Step 3: Barrel Extention (Not Required)

Build this part once.

Step 4: Trigger

Build this once.

Step 5: Putting It Together

Pic 1: put the firing pin in the rear of the gun
Pic 2: put a tanned connector on the firing pin
Pic 3: get this piece
Pic 4: place it on the right rod like so
Pic 5: place 4 white connectors
Pic 6: place a handle
Pic 7: get this piece view pic 3
Pic 8: place it the same way as the other
Pic 9: build this
Pic 10: place it like so
Pic 11: get these two parts
Pic 12: put them like so
Pic 13: Close Up
Pic 14: place a white connenctor with two y-shaped connectors
Pic 15: put on five red connectors
Pic 16: get this part (again)view pic 3
Pic 17: place it like so
Pic 18: Close Up
Pic 19: place four red connectors
Pic 20: place the other handle
Pic 21: get this piece (again again) view pic 3
Pic 22: place it like so
Pic 23: Close Up
Pic 24: Another Close Up
Pic 25: place three red connectors
Pic 26: get this piece (again again again) view pic 3
Pic 27: place it like so
Pic 28: Close Up
Pic 29: place a red connector and a white connector
Pic 30: how the barrel should look like
Pic 31: place a rubberband around the trigger to the bottom of the handle like so
Pic 32: add these
Pic 33: place this on the top of the gun
Pic 34: place it as shown

Step 6: Ammo

A yellow rod with a red connector as shown

Step 7: Rubber Bands Emplacement

Where to place 'em

Step 8: The K.B.K

Have freaking much fun with my gun!!!