K'nex Flip Target

Introduction: K'nex Flip Target

About: Who is this guy!?!?! TROLOLOLOLOL!!!

When you shoot the big target the little target pops out.You will need,
1 grey rod
4 yellow rods
1 big blue panel
1 small blue panel
3 red or grey connector
2 blue connectors
and 3 white rods

Step 1: The Stand

This is what holds up the target.You'll need,
1 grey rod
2 blue connectors
and 4 yellow rods

Step 2: The Target

This is the part that flips when you shoot it.You will need,
1 big blue panel
1 small blue panel
3 grey or red connectors
3 white rods
and 2 black or white connectors

Step 3: Putting It Together

You'll need,
the stand
and the target

Step 4: YOUR DONE!

Know you shoot it if you want to.

Be the First to Share

    Recommendations

    • Tinkercad Student Design Contest

      Tinkercad Student Design Contest
    • Robots Contest

      Robots Contest
    • Back to School: Student Design Challenge

      Back to School: Student Design Challenge

    6 Comments

    0
    RMConstruction

    Looks good, but even a gun with minimal power would knock this over. Sorry, but 3*

    0
    chopstx
    chopstx

    Reply 12 years ago on Introduction

    why, this doesnt have anything to do with power, but accuracy.

    0
    RMConstruction
    RMConstruction

    Reply 12 years ago on Introduction

    No, no. yu don't understand. if a gun has more power, it will push harder. most guns have very high power, which will nearly always topple it.

    0
    Knave125
    Knave125

    Reply 12 years ago on Introduction

    no it's actually very steady so it doesn't fall over much