Introduction: Knex Miniature Piston!
Here’s how to make a simple Knex piston
Step 1: Piece Collection
This step will tell you all of the pieces that you will need to make this piston.
Step 2:
This part of the model will hold the piston and crankshaft up.
Step 3: The Cage
This is the sides of the model tho hold the white connector up to put the piston through
Step 4:
Step 5: The Crankshaft
Now this is the crankshaft look carefully because this step is harder than you think.
Step 6:
Step 7: The Piston
This step includes a long grey rod for the piston
Step 8: The Top
This bit sits on top of the red rods.
Step 9: Finishing Touches
This step will help the piston stand up properly and put an end cap on the end of the piston
Step 10: Finished!
Have fun playing with your miniature piston!
Comments