Lamp From Cooking Utensil.

Introduction: Lamp From Cooking Utensil.

At first I attached a baloon inside the cooking utensil which is made of clay. After wearing latex gloves, I spread glue all over a ball of twine with my fingers and wrapped the twine around the baloon-utensil system. I only left a small area at the bottom of the utensil uncovered in order to make lamp change easier. When the twine was fully dry and stuck on the baloon surface (after some hours), I popped the baloon and took out the utensil any left parts from the baloon. Now there is a curved surface of twine because of the baloon. Finally I passed the wire from a hole at the top of the utensil, connected the lamp and that's it!

Be the First to Share

    Recommendations

    • Remote Control Contest

      Remote Control Contest
    • Digital Fabrication Student Design Challenge

      Digital Fabrication Student Design Challenge
    • Fruits and Veggies Speed Challenge

      Fruits and Veggies Speed Challenge

    Comments