Lasercut Wedding Thank You & Name Card in One

Introduction: Lasercut Wedding Thank You & Name Card in One

I wanted to make wedding place cards that doubled as thank you cards. These we placed in a small flower pot (height: 5cm), which had a cactus in it. Each one was placed on the table to decorate it nicely.

Step 1: Lasercut 5mm Plywood

Use plywood instead of mdf for a more rustic effect. You can put olive oil on it to make the grain stand out even more.

Step 2:

Be the First to Share

    Recommendations

    • Plastic Contest

      Plastic Contest
    • The 1000th Contest

      The 1000th Contest
    • Battery Powered Contest

      Battery Powered Contest

    Discussions