Maplewoodblocks

1,478

15

4

Introduction: Maplewoodblocks

Create a clever puzzle and fidget toy from wood in your backyard. These Maple blocks from Maplewood, NJ, are covered with food-safe coating and are appropriate for kids of any age. Each set is from a single plank so the grain pattern can become a puzzle as well.

These are made from spalted maple from a tree around the corner from our house. We wanted to create an creative toy that also showed the inner beauty of trees that otherwise end up chipped.

Special thanks to Jonathan Sidhu, Mara Pohl, Stephanie Liner, and Erin Doppes for the great collaboration!

Step 1: Rough Milling

Using short sections of Maple or similar wood, cut slabs approximately 2" thick. The live edge will become a design element later in the process so do not cut away the outside. Always wear eye, ear, and body protection.

Step 2: Thicknessing

Using a band saw, cut each slab into 3 planks, each about 3/4" thick. Then, use a planer to reduce to 1/2" on both sides.

Step 3: Rough Cutting

1) Using a tablesaw, cut each slab to roughly 2 1/4" width or in half. For safety, we cut off one live edge. You can also leave that on and use a bandsaw to cut down the middle, then use a jointer to get the cut side smooth.

2) Rip each smoothed plank in half again. Keep each plank together in a set so that you can match grain later.

Step 4: Final Cutting and Shaping

1) Using a router, add a small rounded profile to the long sides

2) Now that you have two halves of each plank, cut to 3.5" length. At this stage you will have 8, 2 1/4" by 3 1/2" rectangles, of which four will have live edges.

3) Using a table saw, batch four blocks and cut dados on sides and ends that are the same width as the thickness of the plank plus 1/32". This will allow the blocks to notch together nicely.

4) Using a disc sander, smooth each end

Step 5: Finishing

1) Now that you have sized and ready pieces, use rubber bands to keep each set together.

2) Put the sets on a cookie tray and put in the oven for 30 minutes at 140 degrees. This will heat the wood to absorb the finish you will apply next

3) Using a food safe finish such as butcher block conditioner, wipe each side of each block and let the finish soak in

4) Wipe away any excess and bundle your blocks

First Time Authors Contest 2016

Participated in the
First Time Authors Contest 2016

Wooden Toys Challenge 2016

Participated in the
Wooden Toys Challenge 2016

Homemade Gifts Contest 2016

Participated in the
Homemade Gifts Contest 2016

Be the First to Share

    Recommendations

    • Toys & Games Contest

      Toys & Games Contest
    • Furniture Contest

      Furniture Contest
    • Big vs Small Challenge

      Big vs Small Challenge

    4 Comments

    0
    midiansangel
    midiansangel

    4 years ago

    These are such a good idea!

    0
    erindoppes
    erindoppes

    4 years ago

    These are awesome. I love that they can be used in different ways!

    0
    Swansong
    Swansong

    4 years ago

    These are neat! Great gift idea for kids :)