This is a cool project I made that you can put on your desk or show it to your friends and see if they can figure out how you did it.

Step 1: Cut

Cut three slots out

Step 2: Drilling

Boil some water and put one end in for about 10 minutes and then clamp it on the vise and let it dry and then get a long drill bit and drill the holes.

Step 3: Sanding

Sand it in the groves

Step 4: Putting the Nail in

Put the nail in the hole and then put it back in the boiling water and let the wood go back out

Step 5: Cut

Cut the side off

Step 6: Your Done

And that's it sand it a little more and it's finished