Obstacle Avoiding Robot Using Tinkercad

In this project, we are going to learn, How to create an Object Avoiding Robot Virtual Simulation using TinkerCad Circuit

Step 1: Components Required in This Project Are:

To complete this project we need the following components

Drag the components from the menu and put them inside the project area

• One L293D(Motor Driver).
• One Breadboard.
• Two DC Motors.
• One Arduino UNO and.
• One Ultrasonic Sensor is required.

Step 2: Circuits Connections

Make the connection as shown in the above figure

Step 3: Coding or Blocks

Make the following blocks as shown in the above image