Introduction: Office Supplies Catapult
Many a times I have been wanting to build something dangerous from something not so dangerous. I went through a “pen gun” phase where I went crazy about building a pen gun. I was somewhat successful but not perfect. I needed a weapon that would bother the guy next to me but not something that would get me in trouble. I came up with this...the 5 minute binder clip catapult. If you are interested, read below.
Please, raise your right hand and hit Next Step.
Please, raise your right hand and hit Next Step.
Step 1: DISCLAIMER
DISCLAIMER:
I, (NAME GOES HERE), HEREBY GRANT MYSELF TO USE SUCH DANGEROUS OF A WEAPON. I PROMISE TO USE THIS IN THE NAME OF GOOD AND TO BOTHER PEOPLE...NOT TO KILL. IF HOWEVER ANY INJURIES TAKE PLACE I MAY NOT HOLD blinkyblinky RESPONSIBLE FOR ANY CHARGES. BUILDING A DEVICE AS LETHAL AS THIS IS OF YOUR OWN CHOICE AND SO, IF I AM CHARGED WITH FIRST DEGREE MURDER, I HAVE NO RIGHT TO BLAME blinkyblinky FOR ANY CHARGES PRESSED UPON MYSELF.
Now, with that out of the way, let us begin.
I, (NAME GOES HERE), HEREBY GRANT MYSELF TO USE SUCH DANGEROUS OF A WEAPON. I PROMISE TO USE THIS IN THE NAME OF GOOD AND TO BOTHER PEOPLE...NOT TO KILL. IF HOWEVER ANY INJURIES TAKE PLACE I MAY NOT HOLD blinkyblinky RESPONSIBLE FOR ANY CHARGES. BUILDING A DEVICE AS LETHAL AS THIS IS OF YOUR OWN CHOICE AND SO, IF I AM CHARGED WITH FIRST DEGREE MURDER, I HAVE NO RIGHT TO BLAME blinkyblinky FOR ANY CHARGES PRESSED UPON MYSELF.
Now, with that out of the way, let us begin.
Step 2: Get Your Materials
You will need:
1 oversized binder clip (use the biggest you can find.)
A handful of assorted rubber bands
1 Plastic Spoon
Someone to Bother (victim)
1 oversized binder clip (use the biggest you can find.)
A handful of assorted rubber bands
1 Plastic Spoon
Someone to Bother (victim)
Step 3: Attachments
First attach securely to the binder clip, the spoon via rubber band. on one end of the clip. (Refer to the first picture.)
Attach a rubber band via loop to the other "arm"(Refer to picture two.)
Repeat the previous step two to three times.
Then, pull over the rubber bands in the gap between the spoon and the arm. (Refer to picture two.)
Assembled and ready for firing!
Attach a rubber band via loop to the other "arm"(Refer to picture two.)
Repeat the previous step two to three times.
Then, pull over the rubber bands in the gap between the spoon and the arm. (Refer to picture two.)
Assembled and ready for firing!
Step 4: Video.
Step 5: Troubleshooting.
Congratulations...and, not so congratulations. If you made it to this step it may mean that you have successfully made this product. It may also might mean that for those of you who didn't build this this project and just read it you don't have a working product.
JUST KIDDING!
HAVE FUN!
As always...if you experience any problems leave a comment and I will try my best to help you.
If you did make it successfully well then...leave a comment saying you made it successfully!
*Any idea on why they call it troubleshooting??? (Rhetorical Question...Maybe Not.)
JUST KIDDING!
HAVE FUN!
As always...if you experience any problems leave a comment and I will try my best to help you.
If you did make it successfully well then...leave a comment saying you made it successfully!
*Any idea on why they call it troubleshooting??? (Rhetorical Question...Maybe Not.)
Step 6: Additions.
I will be adding to this...I hope.