Introduction: PVC Light Saber

By

Today I will show you how to make a PVC light saber.

Things you will need:

at least 3 and a half feet of 1/2in pvc

1ft of "1in" pvc

pvc cutter

Red and silver paint

and electrical tape.

Step 1: "1/2"in PVC

I cut the "1/2"in pvc at 39in, feel free to cut it at any length. (Just remember that the light saber starts a foot up)

Step 2: Paint

Now is when you paint it! yay!!! go ahead and paint it your favorite lightsaber color.

Step 3: 1in PVC

Grab a foot of 1in pvc and cut a angle on one of the ends, then paint it grey.

Step 4: Tape

Decorate your handle however you like.

Then wrap tape around one of the sides of the saber until the handle slides onto it and fits tightly.

Step 5: Finished!

I made two. After a while of fighting the paint will chip off and you will have to repaint.